ELAC Miracord 50 manual turntable

Kaina:
€499.00
Tax included Contact us for delivery time
Quantity
Delivery by order

Make an offer

Your Offer is sent.

Your Offer is accepted, please check your inbox.

  • Use dot instead of comma
  •     *Required Fields

Loading

SPECIFICATIONS

Turntable Section

  • Drive System: Belt drive
  • Motor: DC motor
  • Selectable Speeds: 33⅓ and 45 rpm
  • Motor Servo: Speed rotation and servo system
  • Rotation Speed Variation: +/-1%
  • Wow and Flutter: 1%
  • Signal-to-Noise Ratio: -67 dB or higher (A-weighted) -60 dB or higher (unweighted)
  • Platter: Aluminum die-cast
  • Platter Diameter: 0 in / 300 mm

Tonearm Section

  • Type: Aluminum tube, static-balanced
  • Effective Arm Length: 8 in / 223.6 mm
  • Stylus Pressure Range: 0 to 0 g
  • Cartridge Weight Range: 5 to 6.0 g
  • Effective Arm Mass: 4 g
  • Overhang: 6 mm
  • Offset Angle: 25 degrees
  • Anti-Skating: Adjustment Supported
  • Main Bearing: Stainless steel

Cartridge Section:

  • Type: Audio-Technica AT91 moving magnet
  • Stylus Construction: Bonded diamond
  • Mount: Half-inch
  • Frequency Response: 20 Hz to 20 kHz
  • Channel Separation: >18 dB
  • Channel Balance: 5 dB
  • Vertical Tracking: Angle 20 degrees
  • Stylus Pressure: 0 g +/-0.5 g
  • Cartridge Weight: 0 g +/-0.5 g
  • Headshell Weight: 0 g (including screws, nuts and wires)

Phono Equalizer Amplifier

  • Type :Moving magnet (MM)
  • Phono Output: 5 mV (1 kHz, 3.54 cm/sec)
  • Line Output: 140 mV (-17 dBV)
  • Phono/Line: Switchable
  • Supported Load Impedance: 47 kΩ

Connector: RCA pin jack including RCA cable accessories
Voltage: 100 to 240 V AC / 50 to 60 Hz
Power Consumption: 1.5 W (less than 0.5 W at standby)
Dimensions: (WXHXD) 5.5 x 16.05 x 14.20
Weight: 12.10 lb